Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I am facing some design challenge while designing the DC architecture.
1. I have only 4 ports of routers. Two are used for up link connectivity (bundled) towards ISP and other 2 are used for down link connectivity (bundled)2. Do i really need to ...
Hi Team,
I have few queries regarding the planning phase for migration of 5 application/servers from XYZ datacenter to new datacenter which is presented in the diagram. The diagram provided contain the devices which will be used in the DC. We have ...
Hi,
In the attached diagram,
Brief:There are 2 Nexus 5548 connected to ASA 5585 (Firewalls are active-passive mode, handled by client). These are connected to firewall via trunk. Here firewall is acting as a gateway for all the servers connected bel...
Hi,
Is Brocade 7840 compatible to Nexus 5548UP ?
I have a storage device connected below Brocade 7840. This will be an FC traffic from storage device to Brocade. Brocade will do the FC to IP conversion and forward the traffic to Nexus via VLAN. (T...
Hi,
In the set up attached, Nexus will act as gate way for all servers connecting benith it.
Can anyone please suggest, if i can: 1. logically combine all 4 ports (2 from FW-A and 2 from FW-B) firewalls into a single port-channel group ? 2. logically...
Need VPN for offshore connectivity from the Datacenter. This VPN will be established via the same internet link. The another use of internet would be to provide internet connectivity to servers.
Also can i have a VM in LAN segment where i can have ...
Thanks Jim,
Yes its just ethernet/IP traffic to the Nexus switch from Brocade 7840. But my vendor is saying that both the switch are not interoperable, but I do not see any document saying the same.
Ashwin
My mistake I was unable to post the question correctly.
The set up shown in network diagram is of one site. We have a similar set up in different site.
The purpose here is to create a FCIP tunnel between these Brocade 7840 switches situated at Site ...
