Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,
I have set up a RADIUS Server using Windows NPS is working fine for our Cisco 3750 and 2960 switches. But we add a Cisco SG 200 Switch, we cannot login to that switch via WEBui using a RADIUS account.
Please help. Below is the accounti...
Hello All,
can you advise what the issue on this coreswitch. Show tech logs are inconsistent.
I cannot determine if there is a faulty switch module. Currently Switch 1 is standby (previously active) and Switch 2 is Active (previously standby)
-...
Hi All,
I noticed this error on my previously ACTIVE "now STANDBY Switch"on a VSS Stack
System returned to ROM by s/w reset (SP by processor memory parity error at PC 0x40445D90, address 0x0)
is this a hardware issue?
Redundant System Informa...
Hi All, we are having intermittent issues on our vpn tunnel and i notice the firewall is giving below messages. Site A is using Juniper, Site B is using Cisco ASA 5500 then it goes up after 5-10mis Sep 01 2017 09:27:39: %ASA-3-713902: IP = 203.xx.45....
hi All,
i have followed this link below
http://www.cisco.com/c/en/us/support/docs/ip/layer-two-tunnel-protocol-l2tp/200340-Configure-L2TP-Over-IPsec-Between-Window.html
after i have completed the wizard and check using cli, i cannot see the vpn i h...
Hi Deepak,
is this a hardware issue?
RPI1R03CSW001-sdby#show bootvarBOOT variable does not existCONFIG_FILE variable does not existBOOTLDR variable does not existConfiguration register is 0x2142 (will be 0x2102 at next reload)
Dear Marvin,
thank you for your inputs, apparently i have tested the configuration using Windows 7 and it worked fine. However, testing on the windows 10 PC fails. Any idea why?
FW# sh crypto isakmp saIKEv1 SAs: Active SA: 1 Rekey SA: 0 (A tun...
