Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have stacked two WS-C3750X-48T-S as well as using stack-power cable. I have configured the stack-power mode in redundant then also it's show as 'power sharing' when checked using show stack-power command. Any idea why so ?Below is the configurati...
Hello,I am going to configure the NATing on ASR1002 and expecing to have near about 1Million nat translation. Will ASR1002 support 1million nat translations ?Any idea how many NAT translations are supportable on the ASR1002 ?I am going to configure N...
Hi, In our MPLS network we are planning two add one more WAN link between two nodes of same bw as of existing link, say two WAN link of 200Mbps. As a IGP we are running OSPF and MPLS enabled on the WAN. If the traffic gets load balance on both the pa...
Hi,I am getting the below error while applying the service policy to the Interface. I have set the mpls exp 4 as well as want to limit the bandwidth to 1MbpsPE#sh policy-map setexp-GBoIP Policy Map setexp-GBoIP Class GBoIP-traffic set mpls e...
Hi,I like to know what is throughput of the Cisco 2911, cisco 2921 & cisco 2951 routers. I can see ISRG2 can supports the throughput of 150Mbps.Thanks in Advance.
hithanks for the pdf, I had tried the VPLS earlier. the circuit are coming up but I am not able to ping between CE's Vlan ip address although VC are upPE end configinterface GigabitEthernet1/35 description L2 Connectivity to KBL039SW1 (TEMP) switchpo...
i am facing one more issue.users who are using windows vista and windiws 7 platform are not able to establish the SSL VPN, It's giving the error like "contact to IT Administrator"Is the cisco ASA don't supports on windiws vista and windows 7 platfor...
Hi,Thanks for the reply.without using "management-access inside" can remote users able to access the PC/servers inside the LAN means "inside" interface network (172.16.0.0/24).Regards,Nilesh
I tried your solution , it's working. But when i ping to inside interface IP (172.16.0.1) from remote machine I an getting reply from public IP address.means 202.174.148.35ping -t 172.16.0.1reply from "public IP"How to overcome this?Regards,Nilesh
Hi,No error message when i discconnect from switch & connect itAlcatel phone requires 36-52vdc, 0.1-0.2a.As seen from the sh power inline o/p few phones are detected as class-0 so consuming 15.4w.Now I have configured "power inline consumption 7000" ...
