About jvweigand

jvweigand · 06-30-2009

Trying to setup some POTS lines on FXO ports for the first time, using CallManager 5.1.3, and a MGCP 3845 for the gateway.Both inbound and outbound work perfectly with these POTS lines on an analog phone.I've been able to get inbound calls working pe...

jvweigand · 01-20-2009

We're currently running CCM 5.1.3, and just updated to the latest SCCP Phone Firmware, using 7941s and 7961s. For people who are a member of a hunt list, is there any way for them to tell if a missed call was to them, or do the hunt list? Right now, ...

jvweigand · 01-19-2009

We're getting ready to enable Auto-Registration on our CCM5.1.3 system. Is there any reason to not setup/enable it during business hours? I realize it'll cause a bit of a CPU/Network bandwidth hit when the phones start to register, but anything else ...

jvweigand · 01-05-2009

I've been tasked with checking our existing CCM 5.1 system to see if our VAR implemented any type of QoS at all. I've been going through some packet captures of calls, but I'm not really sure what to look for. I know there's multiple methods and ways...

jvweigand · 09-19-2008

Is there any way to get CUPC to display your status as "On the Phone" when you're using a secondary line, rather than what is set as your Primary Extension? So far I've been unable to figure out any way to do this.

jvweigand · 06-30-2009

Well, another issue now. I have both ports (two POTS lines) set to loop start in CallManager - but when one tries to dial out, it continues to say it's set for ground start. I've tried deleting it, then waiting for a couple minutes, and re-creating i...

jvweigand · 06-30-2009

I was sure I had tried setting it both ways yesterday, but I just set it back to loop start, and boom, it works. Thanks!

jvweigand · 03-16-2009

No, there is no logging yet. I know this has been requested a bunch of times, and I believe it's planned to be in a later release.

jvweigand · 01-19-2009

The DN range we're going to use for it isn't used anywhere else, should we still have it blocked off? Or with no potential for overlap, could we use an existing partition/CSS?

jvweigand · 12-30-2008

We're still on Unity Connection 1.2, doesn't appear that feature is available. Very cool that they added that though, I'm sure we'll use it once we upgrade.

Member Since	‎05-15-2007 09:18 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	53
Total Helpful Votes Received	18

User Statistics

User Activity

Issue with Outgoing FXO over POTS Line

Tell Who Missed Call was To w/ Hunt List?

Enable Auto-Registration During Business Hours?

Checking for QoS?

CUPC Status for non-Primary Extension?

Re: Issue with Outgoing FXO over POTS Line

Re: Issue with Outgoing FXO over POTS Line

Re: Cisco Unified Presence

Re: Enable Auto-Registration During Business Hours?

Re: Automatic Login without Password on Unity Connection