Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,Does anybody know what the difference between the two files?And when will the CISCO-ENVMON-CAPABILITY.my be used?ftp://ftp.cisco.com/pub/mibs/v2/CISCO-ENVMON-MIB.myftp://ftp.cisco.com/pub/mibs/v2/CISCO-ENVMON-CAPABILITY.myI found below descrip...
Hi all,Does anybody know the color of AL LED when cable is not connected but "card type" command configured?The documentation doesn't say anything about it but I can observe as amber when installed the module.Table 6. Hardware Specifications for the ...
I am trying to ping from fa0/0(inside nat) through cellular interface(outside nat) to 209.131.36.158(www.yahoo.com) but it fails.As far as I see the debug output, LCP and PPP establishes successfully but fails to obtain IP address using IPCP.And also...
Hi all,Is it possible to use two of cellular interface as primary?Primary and backup use is not possible as far as I searched in Cisco.com.I don't have two HWIC so can't confirm.Cisco 3G WWAN HWIC Q&A TechnicalFeatures and FunctionsCan I configure th...
Hi all,Does anybody know what this error message means?I searched for Cisco.com and used error message decoder but could not find what this meant.Also searched for google but in vain.Jul 29 01:43:37.081 JST: pq3_tsec_process_receive_packet found uncl...
Hi Joe,Thanks for the response!So you need to look into CAPABILITY file than CISCO-ENVMON-MIB.my fileif you want to see which device/IOS supports the MIB, right?Than why doesn't MIB locator uses CAPABILITY file?When I searched ciscoEnvMonRedundantSup...
Hi Vaibhav,Thanks for the reply.This bug seems to match since the IOS used in customer site is 12.4(6)T10 which is affected.I read the description but could not understand "when the router is switched from h/w crypto to s/w crypto engine".I assume th...
