Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a requirement to have an analogue device that auto-answers. In CUCM 4 you could activate auto-answer on the ATA DN within CUCM, and now with CUCM 7 I see this has gone.How could I get an analogue device to auto-answer using an ATA or FXO car...
HiWe RMA's a fauly Nme-wae-502-k9, the returned module have ACNS 5.5.7 installed and i need WAAS 4.1.3 to be installed. Running the copy ftp install 1.1.1.2 . WAAS-4.1.3.55-k9.bin does not work as it expects WAAS and gets ACNS.I have searched cisco.c...
HiWe have an Avaya IP PBX connected to a 3825 by 4x E1's at Site A. This is connected to an 2MB MPLS wich in turn is connected to another 3825 and a TDM PBX via 4xE1's at site B.All calls flow from site B to site A. During a conversation from site B ...
Hi I am having a problem whereby IP calls coming in over the WAN are being dropped on lifting up the handset. In the past I have had this problem when there is a routing problem but this does not seem to be the case this time. Do you have any suggest...
Hi I am having a problem whereby IP calls coming in over the WAN are being dropped on lifting up the handset. In the past I have had this problem when there is a routing problem but this does not seem to be the case this time. Do you have any suggest...
(SITE A) AvayaIPPhones--- AvayaIPPBX---4xE1--3825----MPLS----3825--4xE1--PBX (SITE B) <<------------CallFlow---------------Also if i run a show voice dsp i see the TX and RX packets counting. However they are sometimes not very equal, but i suppo...
The VG224 is basically a 2600 with FXS ports. I often configure them as an h323 gateway and then treatedd it as standard FXS because it gives you more flexibility WRT DTMF and called party numbers. I have not tested faxing on a VG224 with G3, but i w...
HiYes, it is not a routeing problem as all phones take the same route and some will have a one way issue during the call and other will not.There is no clocking issues on the show controllers E1.This has just recently started with no configuration ch...
Most fax machines I have worked with will not negotiate the speed. They will try and connect at the rate specified. You may get the handshake at 33.3 but might not pass data for the fax.
