Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 data centers each with Internet connections, one on the east coast and one on the west coast connected to a MPLS network. I also have a bunch of remote sites around the country connected to the same MPLS network.I can advertise the default ...
I am having issues with horrible performance on my WAN with several sites. My provider tells me that they are seeing my router recieve from the WAN at 100% utilization for about 5-10 seconds every 40-50 seconds. My MRTG and Netflow don't tell me mu...
I have several instances where executives and support staff have dedicated offices in multiple sites, at each site they have their own number and phone config independant of each other. I would like to get to a point where the phone config is availa...
I am looking at moving from a L2 switched network to a L3 switched network at my access layer. In this design my access layer can consist of 3560, 3750, or 4500 switches with layer 3 links to my distribution or my core.My issue is that in the L2 acc...
I have implented WAAS between sites over our WAN and I am also implementing QOS. I am looking for advice on a situation I am having with policing NetApp traffic where WAAS is implemented. In source site "A" I have some NetApps off an LAN interface ...
That is the template. But if phone 1 has a DN of 1234 and speed dials and BLF set up for 2345, 3456, etc. How do I copy that to phone 2? I know I can do a super copy to copy it initially, but if phone 1 adds another speed dial or BLF later for 456...
No not missing anything... I just didn't know that you could do that, and if that was the best way to accomplish the task. All I wanted to do was have the same config on multiple phones.
I want their extension, phone button config, soft button config available at any of the the phones that they have in any of their offices.Currently they have an extension and DID for each office, I want to assign them one main extension and DID and h...
The sending end is being policed on the LAN interface of the router to 30Mb. If I increase it to 60Mb to counter when the WAAS is compressing at 50% then on the recieving end I get close to 30Mb recieved. Problem is WAAS compression and data reduct...
