Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've searched the web and the forums but can't find the answer to my question. Hopefully someone can fill me in. If I don't configure QoS on a 2960x or 3850, what is the default behavior in regards to dscp/cos markings arriving to the switch from a...
Hello everyone. I have an issue where I'm unsure why one route is selected over another and can use your help. Here's the scenario. I have a 3750X stack that runs EIGRP with my WAN provider's router and my ASA. All neighbors are on the 10.41.1.0/24...
Hello all. I recently upgraded my 5520 to 9.0.1 IOS. Today I tried to apply a capture to my inside interface referencing a simple ACL and I get this error.ERROR: Capture doesn't support access-list <capin> containing mixed policiesI also created a ...
Hello all. I have an issue with some clients that seem to have poor ping times but I can't give the users a reason why. Pinging from all tested wireless clients to their respective LAN gateway router almost always results in 3ms to 10ms response tim...
Hi,I recently installed NCS and have received a major alert stating the following: "NCS disk volume 'optvol' is above the recommended disk usage, more than '50'% used"The VM was created from the NCS OVA file and I only have one 2500 controller in NCS...
Thanks Jon. Sometimes, you just need someone to remind you how you configured things. :). Here's what happened. I'm running IP SLA on ASA to automatically redistribute static routes for L2L IPsec. What I did, though was set the AD on the routes t...
Thanks Jon. I couldn't get the output to filter just 10.0.0.0/8 so I provided the entire output.Here's the output from the ASA.MACTASAFW01# sho eigrp topology all-linksEIGRP-IPv4 Topology Table for AS(99)/ID(65.41.39.48)Codes: P - Passive, A - Active...
I found out late last night from TAC that the error I posted is because the ANY keyword is referencing ipv4 and ipv6. The ACL syntax should read ANY4 to specify ipv4 only in my case. I'll test this later today. Thanks Andrew. You are correct but your...
