Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a core stack made up of 2 12Port Fiber Cisco Switches that are -E a 24-Port 3750-E and a 48 Port 3750.The 24-port 3750 is my Master. I have setup all of my VLAN's and VTP on it. I have a VLAN1 that is 10.38.8.1/21 and a VLAN16 that is 10.38.16...
We are showing this error in CW 2.6 looking at the physical descrepancy report...10.35.x.x has the following ports with trunk mode set to auto and trunkingPort Gi0/1.How can we fix this using CiscoWorks.
We turned on BPDU and now ports will go disabled stating BPDU Guard disabled. I know there is no switch plugged into these ports, and there is no physical loop these ports have either pc's or server plugged into them. Why else could this be happening...
We have LMS 2.6 and I would like to see my WLC 4402 and the lightweight AP's it manages. How can I do this? I added the WLC as a seed device and have the correct SNMP string but it still doesn't show it in LMS.
I appreciate the detailed and quick response. I have checked all that you listed. The only question i have is on #3. The 3750 is part of my core stack so do i actually need trunk ports? I don't now since it is part of the stack.Thanks.
Ok thanks. I have a new question. I have another exact setup just like this on another network. How can I tell what routing protocol the core stack is using so i can make this one the same?
