Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to configure a DID for a particular extension. We have the translation rules in place and I have no other issues with several other phones. However, this one particular extension and number constantly gives me the busy signal when trying ...
I am getting ready to attempt my first ever CUCM, Unity, and Presence upgrade. I am currently running 9.x and want to upgrade to 11.x. My environment is as follows: I have two UC220 servers running VMWare 5.1. I have a CUCM, Unity, and Presence serve...
As of recent, I am experiencing a weird problem on one of my router interfaces. About once a day, I cannot access it via the IP address. A traceroute will fail at it as well. When I console in and check the status, I am seeing that it is up/up. There...
I know that I will be asked for more information on my setup but basically I am going to describe it below (summarized). I have a DR site that we replicate data to. Until this week, we were using an OC3 over ATM connection between two Cisco 3825 rout...
Ok, I have been trying to reset my Cisco 4507 R-E with sup 10GE engines, and I am not having any luck. I have followed the following document:http://www.cisco.com/en/US/products/hw/switches/ps607/products_tech_note09186a00800c4546.shtmlI have tried "...
Yes it is registered and I tested the translation rule and it does strip the necessary digits and gives only the last three which is the extension number.
Thanks, Chris. I am going thru PUT and it showed I had 6 available, but that didnt make much sense to me. So, I backed out and posted the question here as I am really not wanting to involve any consultant on this project. I will take your advice and ...
The other side is connected to a Cisco switch. The switch port stats show no errors of any kind and virtually no utilization. The switch log shows no bouncing or no references to the switch port in question.
So, we changed the TCP window size on the Dell's and that made a significant improvement in replication times. We are pleased with the performance. However, I have one last question. We adjusted the window size on the Dell Equallogic's to 2Mb. The d...
Thanks for the information. I have opened a ticket with Dell on the supported commands to change window size. Now, my question is, will I need to enable "TCP Extensions" on my PIX or ASA firewall to allow for this larger window scale? We are going t...
