This might be something obvious I'm missing, but is there a section of the vManage GUI that shows the FSM and previous/current tasks the vManage is working on?For example, if I make a change to a device template and push the changes via vManage, but ...
Does anyone know of a way to capture OMP packets for viewing in Wireshark? I can only figure out how to capture the outer DTLS tunnel packets, but can't see a way to decode DTLS to find the OMP payload inside.Any suggestions? TIA!
I have a basic Centralized Policy (listed below) attached to vSmart - it matches & accepts Routes & TLOCs from Site 1, and then rejects everything else out to all other Sites (2-999).Everything is working as expected, with Spokes only seeing DC route...
I'm running vManage 20.9.4.1 in EVE-NG, and every time I power-on my virtual topology, the vManage doesn't work after it boots.DTLS tunnels do form from vManage to the vSmart/vBond and Edge Routers, but vManage can't actually send any commands to the...
Does anyone know if there is a CLI equivalent to show ip cef for doing an SD-WAN/OMP lookup?I'm looking for a command that will fully resolve the OMP learned destination to the local IPsec tunnels, showing the full recursive lookup.In the attached sc...
Leaving this in case someone else has the same question, but I found it, and it was obvious... The "Task List" is linked from the small bulleted list in the upper right-hand corner of the vManage GUI:
@MHM Cisco World wrote:We can not use both match OMP AND TLOC since both send in different update.This might be the answer I'm looking for. Do you know any documentation links that talk about this in more detail?
Correct. I understand that is the behavior, that if you do not match the TLOC & the Route, then the routes will not be advertised. My question is why is that the behavior?Does anyone have a documentation link that explains why TLOCs must be matched s...
