Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Problem:I currently have a client with over 50 site to site IPSEC VPN tunnels running GRE tunnels to enable them to use OSPF routing. I wish to build a tunnel from our ASA 5510 to most of these remote sites (most sites are using fairly old Cisco rout...
I have several Aironet 1100 AP's which are configure to use EAP/TLS to authenticate against a Cisco ACS server. We are using Aironet 350 pcmcia cards. This setup had been working up until friday when we moved the ACS server to a new IP address. Since...
I have several Aironet 1100 AP's which are configure to use EAP/TLS to authenticate against a Cisco ACS server.We are using Aironet 350 pcmcia cards. This setup had been working up until friday when we moved the ACS server to a new IP address. Since ...
Hi I am trying to configure a Cisco 876W router as the following.Vlan1 ip address 10.17.64.1I have set up a dhcp pool for this which works fine. The problem is I want the wireless network to be an extension of this VLAN and to assign addresses from t...
Problem also appears inkickstart: version 6.2(16)system: version 6.2(16) This is the version our Cisco recommended to remain on for our N7004 switches.Problem nly occurs on 1 N7K in the core swtch pair
I think you are probably right. I was considering terminating the IPSEC tunnel on the ASA and the GRE tunnels on a Juniper SSG 140 that sits behind the ASA to get around it but it may be cleaner to do as you say and take the hit of installing a cisco...
Hi Thanks for the response.I understand that this does not scale as a solution but as the Older routers belong to a client and not to my own organisation there is very little I can do at this time to influence their current architecture. What I need ...
