Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi AllI am working on one work around in my scenario where i need your suggestion, my goal is to have my L3 switch redundancy along with link redundancy.1) Can i use HSRP for redundancy between 2 3560 switch where on both multiple VLAN is configured ...
Hi AllI have token based Nortel VPN Client based on windows to connect remote network,Now when i connect to VPN from Windows machine that machine is getting out of my Local LAN, but i want to share same VPN to multiple users using Linux machine so th...
Hi AllI am new to multicasting concept and here is my requirement.I have one application server which sends multicast packet in network and at other end the receiver is receiving the same packets as they belong to same subnet.Now the requirement is t...
Hi AllI have, one 3560 switch centrally located and 2-Linksys SRW2400 connected at different location via individual VLAN (3560(vlan1) --to--> 1-Linksys (default vlan) and 3560(vlan2) --to--> 2-Linksys (default vlan)).I need to configure redudant lin...
Hi All,Can any body has idea about STP that is possible to enable STP between Cisco 3560 and Linksys switch?As i found Cisco 3560 has PVST and Repid-PVST options where in case of Linksys there is no any option of such a version, linksys has only Clas...
Thanks Narayan,Just want to confirm,1) If i put 1-100 MBPS link in SW-1-VLAN2 and another of 10 MBPS in SW-2-VLAN2, is it also possible to utilize Link failure redundancy, in case if my 100 MBPS link goes down?- If it is Along with Hardware redundanc...
Thanks a lot Hritter,But actually in my case the client can be at different location so can not have static tunnel in between, this is like i have Multicas Application in my premises for demo so client may vary as far as the location is concern.Can y...
Thanks a lot Francois, for getting time to give your input.I will check with MST in my scenario, further i do not have Trunk between Cisco and Linksys, Linksys is configured with default VLAN and Cisco is on on individual VLAN for linksys switch and ...
HI Actually it is my live network i wanted to configure redudant link which interconnect my branch office to HO so i cant wait up to that time, if there is some time introduction i need to plane accordingly. that is the reason i have just keep the se...
Hi AnkurThanks for the quick response,Actually i have tried by putting both link up at same time and was constantly pinging to node at other network, and as i put the another link up i got unreachable.any idea on this? is it due to the calculation ti...
