I have a brand new C1101 that came with 16.12.4. The command "ip address" is not an option:>enPassword:newswitch#conf tEnter configuration commands, one per line. End with CNTL/Z.newswitch(config)#int gi0/1/0newswitch(config-if)#switchport hostswitch...
I am trying to use a GLC-LH-SM module in a c3048TP-1ge-sup switch. I cannot get the interface to come up. I can see in the logs that it sees when it is inserted and removed. The other side is also a GLC-LH-SM. I am able to get a link when connecting ...
I have a serial crossover cable between a Cisco 1700 and 2691 router connecting two CSU/DSU. The CD light is green and the interfaces are UP and line protocol Down. I am getting the following repeating error on both when running debug ppp nego:Jul ...
We have a Cisco Nexus 4000 switch with the following transcievers and I can't get a link to other 850 nm, sr, mm interfaces. sho interface ethernet 1/15 transceiver Ethernet1/15 sfp is present name is FINISAR CORP. part number is FTLX85...
Thank you for your response.I was aware of this option. Just a little misleading when the Cisco initial setup script asks if you would like to add IP addresses directly to the interfaces when it is not in fact possible.
It is not. This is a very simple static route configuration. cisco C1101-4P (1RU) processor with 1414527K/6147K bytes of memory.System image file is "bootflash:c1100-universalk9.17.03.03.SPA.bin" There was an oversight in previous inspections. Gi0/0...
I received three C1101-4P units. The third unit unlike the other two has a gi 0/0/0 interface. The other two just have four ports gi0/1/0-3. The setup wizard asked me to setup gi 0/0/0 and gi0/1/0-3 on the third unit, so I provided IP addresses for e...
Thank you for your reply.I was just getting suspicious that there was something wrong because the ISR 1100 documentation shows the IP address command being applied directly to the Interface and I did not see any examples of applying IP addresses to t...