Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Currently am running Voice over my frame network PBX to PBX using PLAR.voice-port 2/0 connection plar 7724894!!dial-peer cor custom!!!dial-peer voice 105 voip destination-pattern 7724894 session target ipv4:10.20.252.1 dtmf-relay h245-alphanumeric fa...
Do you by chance have another controller on same VLAN that management VLAN is on ? If so try changing you management VLAN to another VLAN and see it comes up. I had the same issue and after reading the install guide it states the EWC will not come up...
The SSH setting should be under the AP Join Profile AP Join ProfileThe default AP join profile values will have the global AP parameters and the AP group parameters. The AP join profile contains the following parameters – CAPWAP, IPv4 and IPv6, UDP L...
So Cisco has not done a very good job with providing info on the WIPS features on the nextGen gear. The 9115, 9117 and 9130 show they support WIPs detection running AirOS (older controllers) and on the new 9800 controllers. AirOS controllers on...
