Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Can you please sugget the cable type for the card NM-1T3/E3 , when i checked in cisco the cable type metioned was CAB-E1-BNC E1, but i'm worried it has shown E1 type cable. Does the same cable CAB-E1-BNC E1 work for both E1 and E3 links.Please adv...
Hi,My requirement is to check for one-way latency of my link. I have configured ip sla "icmp echo" option for thatConfiguration ip sla 200 icmp-echo 10.97.1.11 source-interface GigabitEthernet0/1 timeout 20 threshold 20 frequency 15ip sla reaction-co...
Hi,I have two location A and B. I am connecting the both location users voice calls thru an E1 line. We have avaya 8600 PBX. All the calls from B will land in avaya PBX which in turn is connected to E1 of router A. Recently only channel 21-30 is used...
I have a 2851 router as CCME in my network. I have one VWIC2-2MFT-T1/E1 - 2-Port RJ-48 Multiflex Trunk - T1/E1 and one 4port FXO. I have a PVDM2-48 on motherboard of 2851. I have c2800nm-advipservicesk9-mz.124-20.YA.bin as IOS and CCME version 7.0(1)...
I am working on a LAN design. The total users are 26000. It is multifloor single building. I would like to know what architecture should I propose - 3tier or 2-tier. Also what should be there in core?
HI, I am trying to configure inter-vlan routing on ASA 5510 with 2960.but its not working.can anyone help me wit this.Please find the below config:Firewall ASA 5510:sh run: Saved:ASA Version 8.4(3) !hostname ciscoasaenable password NuLKvvWGg.x9HEKO ...
Hi clarke,Thanks for the response and the reference document. I was able to download the " CISCO-RTTMON-MIB" and tried to load in my HPOV. I am getting an error " [CISCO-RTTMON-MIB] - Line 6235: Error defining object: found 'nReactConnectionEnable' "...
Dear Clarke,Pardon me if I am asking a silly question. My knowledge on NMS is very poor.Do I need to have this file in my hpov nnm software?Thanks and regardsK.Arun kumar
Hi,After removing the FXO card I am able to proceed further in the configuration. I have completed the configs as per the cisco document. I am trying to make a conference call from my 7941 ip phone. I am getting an error message no line available whe...
