Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Looking for some assistance; knowing that this topic has been covered a number of times.
New deployment of Cisco 7821 - phone receives IP address and TFTP address, but does not register.
Thanks
voice call send-alertvoice call convert-di...
Hi All,I have purchased the following hardware with the following configuration:WCS-PLUS-100 Cisco WCS with PLUS License2 x AIR-CT5508-100-K9 Cisco 5508 Series Wireless ControllerOne controller is in use for Corporate, the other is the Guest Access c...
Hi All,I have WCS 7.0.164.0 and MSE3310 with CAS and wIPS licensing. The WCS is configured to see the MSE, NMSP status is active, CAS and wIPS are up and enabled.Tracking parameters on the CAS have been configured.CAS Notifications have been created ...
Hi,I have a total of 70 CAP 3502 installed, but I am having difficulties managing one single CAP.The problem CAP is running 7.0.94.21All other CAP are running 7.0.98.07.0.94.21 is associated with the WLC, but I cannot see it on the WCS - DHCP option ...
Hi,I have two sites located approximately 5kms apart, they have 72 core SMOF connected between locations.I have a 6509 at the core and a 3650E at the remote, both have GLC-LH-SM SPFs.The interface at the 6509 is not connectedThe interface at the 3560...
OK - solved.
As I hoped, there was nothing wrong or incorrect with my config.
The upstream DHCP server was not configured with the correct pool of addresses; it assigned the SIP phone with the address of the VRRP host. Once I resolved that issue ...
VOICE REGISTER GLOBAL=====================CONFIG [Version=10.5]======================== Version 10.5 Mode is cme Max-pool is 100 Max-dn is 100 Outbound-proxy is enabled and will use global configured value Security Policy: DEVICE-DEFAULT Force...
Sorry to drag this one out again, I'm attempting to get MoH working with UCS as per JS's suggestions, but I am not having any success.I have configured the dial peer with the same multicast address:port that is configured on the CUCM.Do I have to cha...
Thanks Pari,This has solved all issues.CAP 3502i WLC 7.0.98.0 WCS 7.0.164.0 MSE 7.0.105.0CAS 7.0.105.0wIPS 1.0.2066.0I can now see all clients and interferers.Dan
