Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone had a positive experience using Cisco AI Assistant? I've tested it with extremely basic prompts and haven't had much success. For example, I asked a question I already knew the answer to: "Do any switches have a power supply offline?"—usin...
Has anyone else noted that the new Clients page (Network-wide > Clients) is clunky to the point you're barely able to use it? Mine is constantly freezing and requires me to reload the page. I don't have this problem when I revert to the old version.
Just finished setting up a little test lab n my office with an MS120-8FP switch and a CW9162I access point. Nothing too fancy, but it’s a solid setup for trying out configs, troubleshooting, and messing around with new features before they go live. H...
I'm getting the following: "Unidirectional link (outbound fault)" on an uplink port for a wireless point to multipoint setup. It serves as the uplink to 2 other 8 Port MS devices downstream. UDLD is set to alert only so the port isn't being disabled,...
Until recently, when an access point was operating at less than 1Gbps, it would show up in the "Alerting" in the dashboard. For whatever reason, maybe after the most recent firmware update, if an access point is operating at 100 Mbps or less, it no l...
@alessandrodematos wrote:The tool is still under development and needs improvement.Please see the "Has anyone had a positive experience using Cisco AI Assistant?" portion of my post.
