Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I typically follow the queueing recommendations to start with from the QOS srnd (http://www.cisco.com/en/US/docs/solutions/Enterprise/WAN_and_MAN/QoS_SRND/QoSDesign.html#wp1002251) , and wanted to know if there were any configuration recommendations ...
Configured 6504E is Ciscoworks LMS 2.5, but is shows as unknown device in Device Management. DM version is latest 2.05, all other 6509s and 6506s OK. Any suggestions?
Set up authentication servers as per Cisco instructions. When selecting Test for that server, I receive an error message the server did not respond. There is no routing issue, as I access the concetrator from the domain controller without a problem...
The SRND for QOS is helpful to use as a baseline, and then modified based on additional network and application requirements. Joseph, if you do not have any productive suggestions then there really is no need for you to reply.If someone does have pos...
Thanks for your input. This is set correctly as per your recomendations, however it still does not work. Do you have it set with NT or active directory?
Vincent, I do not think that explained this so that is completely understandable. I will have two IPSec tunnel connections across the internet with two separate routers on each side. I will be sending routing updates through these tunnels, and prefe...
