i have a query how to do a load balance and fall back with when wan link fails.in a given scenario like this. serial link 256 ISP1 serial link 256 ISP2 | | router1 router2 ...
inside nw----(PIX506E)---Internet--------->VPN4.x ClientIam using VPN 4.x client and able to login to the PIX iam able to get the IP address from the pool but iam unable ping or access the intenal network. iam attaching the config.please comment is t...
Iam doing a l2tp between the 3COM RAS and the Cisco Router. that is establishing successfully iam able to login the vpn concentratorusing the VPN Cisco VPN client 3.0. Iam unable to ping the 3.3.3.0/24 network iam attaching the configs any suggestio...
assumption.configure one with GRE tunnelipsecyou will be having dynamic routing protocol running in mplsvnhigher metrics can be used to decide which one to act as backup.regards
Wire speed.-----------Wire speed is whatever rate of data transfer a given telecommunication technology provides at the physical wire level. Wire-speed , an adjective, describes any hardware box or function that tends to support this data transfer ra...
Hitry with a new image other than this. it will work some times the IOS might not be matching the checksum or not downloaded fullyyou can verify the checksumhttp://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/ffun_c/ffcprt2/fcf007...
Hi to summarise the things,1) you can use the block of 16 IPS with with CRB. the url is given belowhttp://www.cisco.com/en/US/products/hw/routers/ps380/products_configuration_guide_chapter09186a0080118d24.html#196962) if your ISP Gives gives you the ...