Hi ALl,I am trying to configure a syslog server to log messages from the routers.I am trying on the first router, and i issue the command :LOGGING (syslog ip address)So now the messges should be sent to the syslog server.Now supposingly i want to cap...
Hi All,I would like to get an idea of what hardware i will need and sample configuration for the following scenario:I have my main site with a 3745 router.My district offices (5 of them) have 1841 router.I have ISDN lines installed at all district of...
Hi All,I am wondering, if i can find out the IP addresses that are 'connected' to a switch port, just like i can find out the MAC Address ???Any ideas ???Thanks,George
hi all,I am aware i can set the router to send messages to a syslog server, by using the 'log' keyword after my ACL statement.I am wondering and want to know what other parameters i can observe with a syslog server.Also can you point me somewhere wit...
Hi,I presume i can get 128 kbps with the isdn modem right ???Could i multilink ppp with 2 isdn modems to get 256 ??? or even more ???On the 3745 and i have 3 free slots.On the 1841 i have one free slot.Thanks,George
Ok , i understand that i will have to use the public IP in my ACL on the ADSL connected interace.If i obtain a private IP on my ADSL interface from the ISP, then is it the best method to aply the ACL on the LAN interface and assign it as IP ACCESS-GR...
Ok.I have read a bit about ACLs on switches. It mentions that i can only apply ACLs on physical interfaces if i have teh EI image. I only have SI image so i guess im stack with ACLs for Management interfaces.SO i have to apply the ACL on VLAN1.I have...
Hi all,All replies appreciated and will post Ratings as soon as possible.The guy installing the router said everything fine.So when i get a chance to observe the behaviour of the router i will let u know. I will install two 1841s tomorrow, one of th...