Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
OK, I need some ideas how to solve this problem. This will be a quite brainstorming for you ;).IP addresses are not real, but as in my real situation they are public IANA addresses :).I will describe network situation:PIX running PIXOS6.3 with three ...
Pls, does anybody know how to configure exec and privilege level command authorization based on local user database. I tried that, but I haven't done it yet. pls., write me a short step-by-step procedure. Here is commands which I have configured. Som...
Pls, does anybody know how to configure exec and privilege level command authorization based on local user database.I tried that, but I haven't done it yet.pls., write me a short step-by-step procedure.Here is commands which I have configured. Someth...
I need some informations, how to enable(set) MAC address filtering(verification) on incoming VPN remote sessions(clients).Nowadays, I have configured Easy VPN server on PIX515e through PDM. Verification is made through RADIUS server on internal netwo...
Hi,I need help with password recovery for CISCO 836ADSLoISDN router. I made some password recovery procedures with routers of 800 series in past, but now, I wasn't successfull in finding some kind of step-by-step help for 836 router. I only found doc...
Hi,
I'm not expert on this matter, so take this only as hint/guess. Few informations, which could help you maybe in resolving this issue->
1.I suppose, IP address 10.10.10.141/32 is target host towards which you want to forward traffic.
In that cas...
Thanks a lot. I didn't think that password-recovery procedure for 800 will be good. I found that no password-recovery feature is some kind of protection to disallow password-recovery from console(it sets 0 on 8th bit of configuration register. This b...
YES, it's clear ;o). I was sure(I read it - maybe I didn't understand it properly) that when I will define all parameters in "write net"commnad(IP addr.,path), settings in tftp-server command already set will be ignored. Like this:When tftp-server is...
Yes, I am reside on inside interface now and I have tftp-server configured to outside interface. But that doesn't matter because I didn't make this ->write net :but this(I configured all the parameters-so it is as programmers used to say - overriden)...
AFAIK, there isn't any direct possibility how to edit entries/lines in ACLs. There are not line numbers or something similar. So if you made a mistake you have to start it all over.I tried to write ACL in editor(like notepad) and then passed it to fi...
