Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I ran into a siutation where I had to create a static route based on the source. I enabled ip source route but I'm not sure how this should be entered into the router.i.e I need two static routes for;Any traffic to 0.0.0.0 from 10.0.0.0/8 to be ro...
Hello,I'm trying to install LMS 2.5 and IPTEM 2.0 on the same server. However I can't install IPTEM 2.0 when I had LMS 2.5 installed and IPTEM 2.0 asks me to uninstall whole Cisco Works Application.I could install IPTEM 2.0 first then install LMS 2.5...
We're deploying 24 - 48 IP phones at various locations. They all have new 2800 series router and 3560 (24 or 48 ports) PoE switch.I originally configure 3560 switch to handle all inter VLAN routing for both voice and the data, but other folks told me...
Hello,One of engineer who works for our IP Telephony roll-out project, mentioned that if we plug T-1 from different carrier to the 2 ports MFT module, it will result 'clock slipping' He has confirmed that there will not be a problem if one carrier is...
I've been looking for DSP calculation method on the internet for quite long time but I couldn't find anything.One of my vendor told me that they used DSP calculator on Cisco web-site to accomodate customer's requirement.Since we don't know how to gen...
I see what the problem is.Catalyst 3550 series switches have hardware based forwarding, thus forwarding information is programmed in Ternary Content Addressable Memory (TCAM). In order for the TCAM to support Policy Based Routing (PBR), it should be ...
Hi Giuseppe,I have IOS 12.2.50(SE3) IPSERVICE-K9.Switch accepts all PBR related command but I just can't see IP Policy route-map statement under the respective VLAN.I tried the same thing in my 3550 switch (same IOS level and feature set) but same re...
Giuseppe,I tried your suggestion but unfortunately it didn't work. Maybe I should give you more details regarding our setup;I have Cisco Catalyst 3560 L3 switch where all internal VLAN (10.34.x.x/16) resides. We also have ASA 5540 and 3800 series con...
Again, thank you all for your help on this. Is there any other ways to route packets based on the source and destination in secure manner without using source based routing?
