Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to find out if you can do manual pruning on trunk links on downsteam switches that are clients in my VTP domain, without enabling pruning on the VTP server? I have low end switches that have met the max STP instances and need to prune these p...
Should the invent txclock command help eliminate some of the high errors seen on these Hssi point to point connections? I'm looking for a solution that will eliminate these high errors seen. Of course the provider always says no trouble found. The...
I have a new server that I want to load LMS 2.6 on. The cd's that I have are the full version of LMS 2.5 and the upgrade cd to 2.6. My question is do I still need to load the LMS 2.5 full version befor loading the LMS 2.6?Thank you,
We have a wide range of switches and I'mtrying to find a quick way to tell if it has an IOS or a CAT image. Using the sh ver I'm unable to tell. Is there a quick way to do this? Thank you.
I am unclear on this. My plan is to add it to the GigabitEthernet channel only and hope that it propagated the trunks. I am going to have to validate this. If not I'm doing the individual trunks as well.
Giuseppe, what is the best method to view the stp instances after this change? Meaning I want to check the stp instances after doing:switchport trunk allowed vlan remove 2-4095!swithport trunk allowed vlan 2,3,4!Thanks,
I will have to prune because I have 128 VLANS and growing. I am at the max 128 max stp instances on my low end switches. If i just allow certain vlan through I will effectively still have 128 instances because of the VTP is still propagating these ...
