Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is this a valid ACL?access-list OUTSIDE_access_in extended permit tcp host 160.83.89.0 255.255.255.0 anyIf I want to allow this address incoming to any internal address?
How do I create an ACL that would only allow specific sites to go through if I didn't know the IP and only know the DNS name. Say I want to allow only these two sites *.cisco.com and *.yahoo.com then block all others. Can I do that?This is on an AS...
In order to change the .bin file on my 2811 router can I just delete c2800nm-advsecurityk9-mz.1243h.bin and replace it with c2800nm-advanterprisek9-mz.124-6.T8.bin?Is that allI have to do to reload it?This is the first one I have had to reload the IO...
I have two T1's coming into a 2811 router. How do I set up the FastEthernet 0/0 to handle this traffic from both T1's?Here is what I thought but not sure it is right.interface FastEthernet0/0 description Connection to office ip address 192.168.99.3 ...
I am trying to let in any address from that 160.83.89.0 subnet into my outside interface. Is that possible to do or do I have to get exact IP's of individual PC's in that network range? When it is requested from any of my internal IP's.
I am trying to make it so that only the data going from my internal 47.15 gets nat'd to 3.21 and info going to all other locations continues as was stated before. The firewall is currently working in the enviroment as:global (outside_datae) 1 192.16...
