Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Got 79% through adding a 140AC. Told me to connect to my new SSID. I can access the Internet, as can others, however the app cannot add the 140. Removed and re-installed the app, and tried to create new site and discover the 140. 0 devices found.
Adding a device using the Android App. It gets to 70% (after asking me to connect to the new SSID) then gives an error Could not add device (see picture)
I have a new 140AC. It cycles through, gets to stage 8, the briefly hits stage 9 for about 5 seconds then cycles back to stage 8. And keeps doing this.
https://www.cisco.com/c/en/us/td/docs/wireless/access_point/csbap/CBW_Admin/Admin/en_US/b_Cisco_AP...
Hi. My customer has 4 WSA's being managed by an SMA. When I register the PAK for
WSA-AMP-LIC=
WSA-AMP-3Y-S2
During the registration it asks for a serial number. Which serial number should I use - the SMA (which did not work) or one of the WSA's. I ...
Hi. I do not appear to have the Services menu option.
I did reset the 140 and attempted the setup again. Similar issue (screen shot attached) 'Could not add device' 'Could not found device' (you may wish to ask Cisco to check the grammar of the secon...
Hi Min G. Many thanks for the reply. Debug log attached along with a screen shot. My phone is attached to the 140 and working fine, I just can't configure it as the app reports 0 devices found.
Hi. You need to set logging trap to notification as the alert Prime needs is a syslog trap as below:%SYS-5-CONFIG_I: Configured from console by ......This is also required for auto configuration archive after a config change.
