Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Reload power-cycle commands coming up with the warning !!!Warning! This command will erase binary configuration in this VDC and reboot the system with ascii configuration. Do you wish to proceed anyway? (y/n).
Has anyone seen this before?
Symptoms
Just want to share additional steps required for upgrade process on Nexus 3000 which I encountered during on-site RCM. In my case, the upgrade path is nxos.7.0.3.I6.1 à nxos.7.0.3.I7.1.bin. On the Cisco Nexus 3000 Series switches, the boot...
Hello, Hoping someone could answer the question. Following bug states that "no negotiate auto" was provided as a work around for Nexus 3000. But I know from personal experience that "no negotiate auto" on Nexus 3000's QSFP-40G-CR4 would cause "link f...
Came across following bug while carrying out assessment for N1000v. Has anyone came across this yet? This seem to be a serious bug.
Symptom:ESXi host becomes unreachable because of a PSOD in sf_qos_list_set(). The entire backtrace looks like the fol...
Issue
switch# show install all impact system bootflash:nxos.7.0.3.I4.1.bin (Note - there is no option for “show install all impact nxos”)
Installer is forced disruptive
Verifying image bootflash:/n3000-uk9-kickstart.6.0.2.U6.6.bin for boot variable "...
Cisco mentioned
"After a successful power sequence upgrade, you must switch off the power to the system and then, power it up."
What's the complication if we do not hard power-cycle the nexus after Bios/power-sequence is upgrade? There is lack of C...
