Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all.I tried to switch on SSO mode on both wlc 5520.If I enter SSO mode on the second node I got an error: >config redundancy mode sso
WARNING: 1. If peer unit's management and/or redundancy management entries are present as mobility members pleas...
Hello.The problem is that under Interface Configuration RADIUS (IETF) AV pairs Primary-DNS-Server (135), and Secondary-DNS-Server (136) didn't displayed. How to make it visible ?F.e. for TACACS+ I can add new service, but I don't see any way to do th...
How to configure 5300 to works with dialup and voice traffic simultaneously ?Now I can dial in to 5300.But when I tried to set VoIP session I get message "Destination out of order" (see debug isdn Q931 command below).Where is a problem ?On the other ...
This message appears when someone press a Corporate Directory button.CallManager has an installed ActiveDirectory plugin.All Sps and WinOS updates were installed.As I know - I'm not alone with this problem.See previous conversation:http://forum.cisco...
When a user press a Directory button a message "Authorization required" appears with username prompt and password.All users have this problem.I tried to enter any userID and password nothing happened.Any idea how to fix that ?CallManager cluster with...
HI, I have already the same firmware version.But on first node it is placed on primary partition, and on secondary node - on secondary partition.Now I will try to upload again the same firmware to primary partition.
Hi Paul.Is there any possibilities to add a pause with MGCP configuration between CCM and VoIP GW?I need to wait a new tone signal after first digit.Thanks.Regards.
Yes. I have Quad E1 card, Voice DSP card (AS53-VOXD), and Digital modem card.-- snip Serial config --interface Serial0:15 no ip address encapsulation ppp autodetect encapsulation ppp isdn switch-type primary-net5 isdn protocol-emulate network isdn in...
Hello Chester, You 're right.After restarting IIS I can sometimes use Corporate Directory.Later I got error messages in EventViewer from DCDirectory attached below.What is a reason ? Incorrect installation AD Plugin at Subscriber, misconfigured passw...
Hello Tejal.Of course I've configured all QoS requirements earlier (when customer have a PPP connection via serial link).Now he is moved to Ethernet connection to SP with bandwidth restriction to 512k.In this situation I'm not sure, that I can do the...
