Question: does the Virtual Machine hardware should be updated after upgrade from 5.5 to 6.7? No it says: Compatibility ESXi 5.0 virtual machine and seems like all is working fine but not sure if it should be upgraded to 6.X
Hello, We do have SIP trunk and I am trying to set a different outbound DID than on my SIP trunk. DID is added in the trunk on SIP provider. I was trying to use External Phone Number Mask but no luck. Is there other place I can use to set that up?
Experts,
I dont see IPV4 and static route like in SG350 switch. SG200 & Sg300 seems not to have it but its have to be the place where I configure static route. Any advice?
sorry - none of the above answers for my case. We figure it out b y using Calling Party Transformation Patterns so now all outbound shows like they should.
Thank you again Tony & Roger, if you say so that with MGCP there is nothing can be done on the voice gateway and the only way is to use CCUM I found this https://www.youtube.com/watch?v=sYqI6O_9_mM I wonder if this is exactly what I need.
Since I have already some configuration and just be adding blocking just one specific inbound number so I should do this: config tvoice translation-profile call_rejecttranslate calling 2voice translation-rule 2rule 1 reject /915403328054/dial-peer vo...
