Cisco sg200 & sg300 static route using GUI

[sprintership-il]

Experts,

I dont see IPV4 and static route like in SG350 switch. SG200 & Sg300 seems not to have it but its have to be the place where I configure static route. Any advice?

[mkazam001]

this might help:

https://community.cisco.com/t5/small-business-switches/set-static-ip-on-sg350-28p/td-p/3329457

regards, mk

[sprintership-il]

well sg 200 and sg 300 they both have different gui than sg350 so its not a solution, sg 300 has ssh byr sg200 I dont see it anywhere to enable