Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello experts,I have a 3825, running 12.4(22)T (c3825-ipvoicek9-mz.124-22.T.bin). The chassis has the following modules:WIC-1DSU-T1-V2VIC2-2FXOPVDM2-8NM-16ESWPPWR-DCARD-16ESWNME-WAE-502-K9This unit is in a small branch office, and there is no other s...
Is there a way, via LMS, to locate the serial number of the original device in a situation like below?Original device OE-612 - OID = 1.3.6.1.4.1.9.1.777New device OE-674 - OID = 1.3.6.1.4.1.9.1.957 (note, hostname & IP was changed, so identity was up...
The NME-WAE-502-K9 shows as an unknown device type in RME. The SysObjectID returns as .1.3.6.1.4.1.9.1.1210; however, the RME supported device table says it should be 1.3.6.1.4.1.9.1.823. I have confirmed the device credentials are correct. The inven...
I have a handful of 6500 that I cannot get inventoried successfully; however, some 6500s are inventoried successfully. I am running LMS 3.2. I have confirmed the SSH & SNMP credentials are correct. I did a device update in CS, but still no inventory....
Hello,Let me start by saying I am a UC500 & voice newbie. I am helping a company with a UC540 install, and I have a question.Is it possible for 3 users to share one phone with the following:1. There will only be one person, of the three, using the ph...
The powers that be need to add my hardware/software config to the following bug id:http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCsz52576CSCsz52576 Bug Detailsvlan.dat file lost after second power cy...
Derek,I figured that had to be the case. Thank you for looking into this & submitting for the OIDs to be added to the device package. I will watch for the updates.Drew
Hello & thank you for the response. That was the first thing I did when I noticed this problem. Now if I do a "check for updates" I am presented with a pop-up box that states: "All the available package(s) at source location are already installed....
Sorry Joe, I should have known your response was dead on & I should learn to follow all of the directions. Because there were multiple devices failing, I did an inline edit on all of them. It works a little different like that, and I failed to do the...
Thank you for the prompt response. I did as you suggested and it did not seem to work on the devices I need it to. Interesting note, the devices I am having an issue with are all running a 12.2(33)SXI version of code. The others are running 12.2(33)S...
