I have the following error regarding my Vstack director configuration.
if someone can help me to fix it. I'll so much appreciated.
Director IOS: System image file is "flash:/c3750e-ipbasek9-mz.150-2.SE10a.bin
Client WS-C2960G-48TC-LIOS: c2960-la...
Hello All.
I Have the following error trying to upgrade the NX-OS in my N3K-C3064QP-10GE
test1# copy tftp://192.168.0.130/n3000-uk9.6.0.2.U6.5.bin bootflash:n3000-uk9.6.0.2.U6.5.binEnter vrf (If no input, current vrf 'default' is considered): man...
I have a module A9K-MPA-4X10GE in slot 0/0/0 which the Oper State : DISABLED anyone has been there to help me to figured this out.
any help will be appreciated.
Please see below my output.
*****************************************************
...
I have WS-X45-SUP8L-E on chassis 4506-E trying configure. but I received and FPGA'S error. here is the output anyone has been there and have a clue how to fix it. any help will be appreciated.
Please see below my output I tried to boot from TF...
Press Ctrl + C to boot loader.GNU GRUB version 0.97
Autobooting bootflash:/n7000-s2-kickstart.6.1.2.bin bootflash:/n7000-s2-dk9.6.1.2.bin... Filesystem type is ext2fs, partition type 0x83Booting kickstart image: bootflash:/n7000-s2-kickstart.6.1....
Leo
The client switch is factory default there is no configuration on it.
the director is 3750-e
*******************************************************
Switch#show vstack config Role: Director (SmartInstall enabled) Vstack Director IP addre...
I'm not sure if in order to make the line card works do I need to upgrade the license?
I power-off the module and re-insert same results.
Thanks of both of you guys.
Best regards.
here is the syslog.
***************************************...
I think you need to define the interface Fa0/2 as trunk port that way the trunk port will carry the traffic from all vlans. and also pls verified that all vlans are up.
Switchport mode trunk
encapsulation dot1q
allowed vlan 10, 20, 30...
