Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have migrated ASA to FTD, but the tool did not migrate any OSPF configuration. Why is it so?Am I missing something? or making any mistake?ASA Config OSPF
*****************
router ospf 2router-id 192.168.180.5network 192.168.180.0 255.255.252.0 area...
Hi,I am migrating from ASA to FTD with the help of FirePower Migration Tool.I fetched the startup-config from FTD and manually parsed.The FMC is connected successfully and it detected the FTD but when selecting the FTD, it says"the selected device co...
I am using [nxos.7.0.3.I5.2.bin] on eve-ng, the scenario is attached, and so is output.I cant configure VPC with downstream switches, (Also Nexus same model).All configuration is fine, i checked both with LACP Active and ON, same results, I changed N...
I have obtained a realtime IOS from my cisco 3750 switch via copy flash: tftp: c3750-ipservicesk9-mz.122-35.SE5.bin
It is copied to tftp server
Now i have tried to run it on GNS3 by clicking "Preferences" and then creating new IOS image, but it gives...
You should use two interfaces in the virtual DNAC and two subnets [192.168.1.0/24 & 192.168.2.0/24], both should be routable in your domain and should be reaching out to Internet.1st for Cluster Intra-LinkIP and Mask Only [192.168.1.100/24]2nd for OO...
Thank You for replying Marius.My issue is resolved by Hard Rebooting both the Devices.I Powered off both FTD's and Powered-On the Active FTD first, after five minutes the secondary one.Thank You
