Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I need to deploy Netflow for IPv6 on my Cisco Cat6500, but i am unable to see the configuration commands.From the config guides - this should be pretty straight forward:SUMMARY STEPS1. enable2. configure terminal3. ipv6 flow-export version 9 [ori...
Hi,I have 2 x Cisco 6509-E switches running BGP for IPv6 with my ISP. Bizarrely, the BGP session establishes fine, but i do not learn any prefixes after the session is established. That is, until i add the 'neighbor x:x:x:x::y ebgp-multihop 2' comman...
Hi,I have an ASR1013 with an RP2 and i am unable to boot the ios from either the bootflash: or the usb0:.I am getting an issue:SHA-1 hash doesn't matchboot: error executing "boot bootflash:asr1000rp2-advipservices.03.13.00.S.154-3.S-ext.bin" I have t...
Hi,I am trying to run a capture on one of my ASR 1002 routers, however the EPC monitor capture command is not available.Please can someone provide some insight on how i can either resolve this or an alternative method. I am not on site to make any ph...
Hi,I am trying to upgrade my WS-C4948-10GE from ipbase (cat4500-ipbase-mz.122-46.SG.bin) to enterprise (cat4500-entservicesk9-mz.122-54.SG1.bin) so that I can run some BGP routing. I pulled the code from Cisco, tftp'd to the switch ensured the conf-r...
Ref this issue, the rommon upgrade was the correct path to take (this should have resolved the problem, however the rommon upgrade failed and this was put down to a fault module). Cisco replaced our RP with a newer version of rommon code, we were the...
My understanding of this is that you can have 2 normal Vlans (inside and outside) and these you can configure to pass traffic between the interfaces. The restricted Vlan allows you to connect to the DMZ from the outside, but prevents you from being a...
Hi Ashan,Thanks for you response - the current setting is at 5%.I never noted this setting previously - is there a max recommended? I am still awaiting feedback on the size of the actual share.KRLee
