Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an internet connection to comcast. When I look at the interface stats on my cable interface I see a lot of output drops. What could be causing this? Here is the results from a "sh int c0/0/0 from my router:Robrouter#sh int c0/0/0Cable-Modem0/0...
Can you use a cloned hardware address with the this cable modem? I have an active linksys cable modem but I would like to replace it with an HWIC card.
I have a problem pinging a wireless device from my wired lan PC. I have a 1841 router with a hwic-ap. The wired lan connects via an unmanaged switch to one of the fastethernet ports on the router and the second fastethernet port connects to a cable m...
Thanks for responding,there are two configs, one from the hub router and one from the remote site. The two are connected over a WAN circuit.The hub config contains all of the relevant voice info along with tftp files. The remote site config shows the...
Thanks for responding,The wired lan is on 10.10.1.0 subnet and the wireless lan is on the 10.1.3.0 subnet. I can not ping the wirelss converter from the wired lan. I can ping the converter from the router. Also the ethernet converter does not allow m...
