Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi community,
I have the following case, if someone had the same scenario, please your support.
My end customer acquired initially two C9407 with only advantage suscrip. and without C9400-SUP-UPG-LIC=.
When they received the switches saw that the li...
Hi Community, I need support about a issue with FTD and SSL VPN. when attempt to connect from Anyconnect i get a message saying "cannot connect to this gateway. Please choose another gateway and try again' When I verify the logs on the FMC in the opt...
Hi community, I have a doubt with the next: I have a topology with a vPC domain, two switches Nexus in core layer and 4 nexus in access layer. Additionally, I have a switch catalyst that I need to keep in the topology connected to a trunk to one of t...
Hi guys, I would like to know your experiences when you configure vpc with hsrp (active / active) and test the high availability of the equipment simulating the failure of the primary.On time I would like to know if even when it is an active / active...
Hi Community, In this opportunity i need help with the configuration of SNMPv3 in 9.3.1 version. I have set the basic parameters: snmp-server host .... snmp-server user .... I will skip the other parameters necessary for its operation .....Now my ...
Hola Diana, Te detallo la configuración que uso para apuntar el tráfico hacia el servidor snmp y vrf que debe rutear el tráfico: snmp-server source-interface traps mgmt0snmp-server source-interface informs mgmt0snmp-sevver host x.x.x.x use-vrf manag...
Hola Diana, Gracias por tu acostumbrada respuesta. Si así mismo los tengo, conectados directamente. En las dos pruebas realizadas obtengo sólo 2 timeout desde que el primario cae y luego retoma su rol. Permíteme aprovechar esta misma discusión para c...
Hola Diana Entiendo que indistintamente de por cual vrf decida mandar los traps al servidor snmp , debo indicarle tanto: snmp-server host x.x.x.x use-vrf "nombre vrf"snmp-server host X.X.X.X source-interface Eso mismo he hecho indicando la vrf mana...
