Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi all , i have a question about Jabber 12.6 for Android . Or customer tested with couple different Bluetooth headsets types ( compatible with Jabber ) and found he cannot answer call on headset button. When customer receive call he should press A...
I am running Unity Connection v8 ( we have same problem with v7 on another site ) and am trying to fix the problem with caller ID for external calls . When i get a call from external line and caller leave voice mail message the caller ID should be ...
Hello All,This is my first time doing integration between Cisco and Avaya . I am integrating an Avaya IP Office 500 with Cisco Call Manager v 7 . I have a 2911 GW . All on the same side . At the moment Avaya IP Office 500 connect to PRI line . The p...
Hi all . Is anybody see this issue before ? i have SPA 9000 with Mediatrix 4402 installed , the problem is that 1st attempt of the 95 % of the calls dropped and i getting busy signal , but call is going no problem from second attempt if i dialling sa...
Hi Allat the moment i configuring 9000 box with Mediatrix 4402and hve difficulty with incoming calls , using step - by - step instruction but didnt recieve calls , software SPA 6.1.51. Outgoing calls fine2. when i make debug on gateway it show that l...
Hi Allthanks for a help , this customer has a window to reconnect the line and test it for weekend only , i will reconfigure gateway on Saturday and let you know result . Regards . Alex
hi , Gateway was restarted after configuration of MGCP , switch type is correct , modul set up correct - i see endpoint on gateway , the gateway visible on CM ( if setting is incorrect you not will see ip address on the gateway page in CM ) , but MG...
hi Jamesi tried use this way first - create no MGCP controller and assign internal clocking , but the controller was down , i didn't apply isdn protocol-emulate network command , where this command should be applyed - on controller or on serial...
hi , i have no connection to site at the moment - but i remember that isdn status was DEACTIVATED , on call manager i was configured MGCP gateway , it showed ip address of the gateway and unregistred , i tried different protocols setting - but not ...
