Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am wanting to upgrade a few APs that are currently VxWorks. I have been able to do this on a couple using CAC but this takes forever. I have tried to get WLSE to see them. It can see all the APs that are running IOS but it will not see the VxWorks ...
I have a phone that is not having comfort noise on it most calls. I am looking for some pointers in troubleshooting it since comfort noise is turned on and should be working. Thank you in advance for the help.
I installed the Active directory plugin when all my users were in a container called users. Since then we have migrated to having them in a Organizational Unit called accounts and then department OUs under that. Since we started making this migration...
I was told by a tech from the TAC that I could set up Attendant Console to use the sound card and not a phone. How would I go about doing this. Any help would be appreciated.
I have CCM 3.2 and am using a 2651 with a PRI Card in it as my main outgoing and incoming gateway. At al remote sites I am putting 1751 Routers with FXS and FXO Ports. The FXO are working as remote lines in failover mode. The issue is that I am tryin...
Had looked at this doc before but went back and walked through the config and set the access points up this way again. WLSE still can not see them through SNMP. WLSE actually says Device is SNMP unreachable during the discovery process. It just seems...
Nope. This was fixed by turning of comfort noise and VAD. I have high bandwidth links and did not need to have silence suppression on. I was under the mis imppression that silence suppression stop the silence on a phone when actually it stops transmi...
Just a thought...but I had problems with my VPN passing traffic and had a person who could login but not get into inside servers... I found that my router admins had left off some important routes...once I had routing going I was then able to pass tr...
Actually comfort noise is the white noise generated by an endpoint to suppress the complete silence inherent in a digital system. The analog systems all have some form of this white noise due to wiring and static. In our digital world we have to gene...
Any time I had to do this I just reinstalled over top of the exsting install and had no trouble whatsoever. I hve reinstalled twice once due to me putting wrong info in and another time due to a change in OU structure. Both times went off without a h...
