Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm testing Cisco ISE Posture, have a strange situation and is when i applied a Posture condition to a Authorization Policy Rule the client fall into the Default deny access Authorization Rule, if i remove the condition the client is successfully ...
Hi everyone, I'm trying to setup correctly a encrypted sip trunk between a CUCM (12.5.1.11900-146) and a ISR4331. I have configured a PKI structure with a SUB and ROOT CA. The dial-peer on the router side brings up almost intermediately but on the ...
Hi,
I can't enable the 5Ghz radio on the AP AIR-AP2702I-UXK9, can't configure on root, can i change the -UX domain to another where i can use the 5GHz radio ? Also i'm getting a extreme low speed performance on 802.11ng clients.
ap(config-if)#stati...
Hi,
I've installed a ACS 5.8 with a Internal User database, its have configured that the users can change the password at fist login, the system allows you change the password but it's not syncing, when you exit of either device it's prompts you agai...
Hi,
I'm trying to config a Cisco 2801 IOS 15.1M10 with a SIPTRUNK to one service provider. The calls are working fine incoming, but incoming not. The service provider told me that i need to change the extension number and ip address from to a one ...
Hi Bob,Thanks for taking the time to reply. We do currently have the Premier licenses. Additionally, here are the ISE Overview logs with both case results.Thanks again and in advance for your help.
Update in this case!I've just do thisChange the trustpoint on SIP-UA configuration tosip-uatransport tcp tls v1.2crypto signaling remote-addr 192.168.2.0 255.255.255.0 trustpoint ROOTCA Then i got this msg error "CRYPTO_OPSSL: Can't find router cert"...
