Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a Cisco 2811 verwion 15.1(2)T2 and a PIX501 version 6.3(3). I have configured an IPSEC VPN betwene the devices over the internet and all works well for the duration of the ESP SA lifetime (3600 seconds) and then I cannot get any traffic ov...
Hi,I want to be able to control the configuration the users change from both ASDM and ssh session with the ASA in multi context mode.I am able to get what I want without the use of the ACS (currently using version 4.2 on Windows)I am doing, what I th...
Hi,I am seeing High CPU on a ACE 4710 when using the Device Manager. The software versions are below; ACE 4710: A3(2.5) Device Manager: 1.2This does not happen when on the CLI and have also noticed that sometimes it takes several minutes to complete ...
Nilz,In regards to the licensing and the quote from above 'Please note that Sizing for Cloud Web Security (CWS) is based on named users. This isn't concurrent users but total number of users who may browse the internet.' Is this implemented via IP ad...
Hi Praveen,My thoughts exactly regarding Phase 2 rekey.The tunnel stays up I can see packets being encaps/encrypt'ed at both ends but no decrypt happening.I will post the show and debug commands a little later as am about to head out.Also, I have don...
Hi JG,I understand this but am still getting the following error even though the command is allowed;command unknown: service=shell cmd=show versionThis is seen on the ACS server when trying to bring up ASDM for the said context.Not sure why as the co...
Hi JG,Thanks for the reply.I have been able to get that functionality working ok but what I actually need is a cut down priv 15 set of commands as I want the users to be able to configure from both ASDM and ssh access but only certain commands.It see...
