Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have PIX 515 running Version 6.3(1) with 32MB RAM and 16MB Flash. When I added the 4 port module, the pix will only recongnize 1 of the extra ports. Then when I do a show version, I see the line that says, Max Int: 3. How do I get this PIX to rec...
I have a Unity server set up to support 2 seperate locations. When a person dials 0 while in someones voice message it goes to only one operator. What I need to do is have certian extions go to the operator at location 1 and other extensions go to th...
I am running per-destination load sharing over a WAN with static default routes and I have noticed that the first default route in my routing table consistantly gets 50% more traffic than the second equal cost route. Does anyone know why?
Did you apply it to the inside interface? I would also recommend enabling IP CEF if it isn't already turned on. I implement policy routing all the time. Send me your config and Ill check it out.
It appears that because the SVC setup fails and the interface is not physically down, that it never attempts to use the second policy map (ie permit 20). A Cisco TAC engineer said it can't be done, but I question that answer. My # is 804-342-1909 if ...
