Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
we setup a new DHCP scope and setup a couple PCs to get their IPs via the new scope.now the PCs with the new DHCP addresses cannot ping any 2960 that's on VLAN 1. but they're able to ping everything else on VLAN 1.the switches in question are config...
so, i have 4 switches. one switch feeds the other 3 switches that are in different locations.i have config-ed a vlan 500 with an IP of 10.30.13.0/28. enable EIGRP, etc. and attached a port to that vlan. On the remote switches, i'd like to have the r...
i'd like to upgrade my ASDM but if i remember correctly both the ASA and ASDM have to have the same versions.I pulled the following off of my ASA5505Cisco Adaptive Security Appliance Software Version 8.4(4)Device Manager Version 6.4(9)Compiled on Mon...
I have a 2006 WLC with 6 1242 APs and was wondering what should I expect when I replace 1242 with an 802.11n AP.i know that the new AP will not run at full speed but other than that, I don't know.Any thoughts on this?Thanks, Gary
i have a 3750 SW that i have config-ed an interface VLAN102 (IP 10.35.40.254) and i cannot ping it. this SW was a master SW in a 2-SW chain and this interface has been around awhile. here's the rub: the devices that have the 40.254 as a gateway canno...
KWCHSW40#sh ip routeDefault gateway is 10.30.47.254Host Gateway Last Use Total Uses InterfaceICMP redirect cache is emptyKWCHSW40#Show ip inter br | ex unInterface IP-Address OK? Method Status ProtocolVlan1 10.30.47.235 YES NVRAM up upFastEthernet0 1...
