Hello everybody,
I am installing Cisco ASR1001-X with the software asr1001x-universalk9.16.03.04.SPA.bin.
Apparently it supports only 64 port-channels numbers (1- 64). I am connecting the router to a device with higher Port-channel numbers and I wo...
Hello everybody,
I am installing Cisco ASR1001-X with the software asr1001x-universalk9.16.03.04.SPA.bin.
Apparently it supports only 64 port-channels (1- 64). Is there anyway to extend this range?
Cheers
David
Hello,
we have a PE router ( I will call it PE_X) in our MPLS VPN backbone whose Loopback0 IP cannot be reached using the the "ping mpls ipv4" command. An attempt to do so generates the following output:
R1# ping mpls ipv4 X.X.X.X/32
Sending 5,...
Hello everybody,
we have been pondering on this problem for days without a solution.We would like to restrict the ssh access from a specific source IP address to a given vty. let's say whenever source A with IP X.X.X.X logs in it will be redirected...
Hi I am having the same problem. here is the output of the "show dmvpn detail" [on the tunnel that's down". Interface: TunnelxxxSession: [0x14566F74]Crypto Session Status: DOWNfvrf: INET, IPSEC FLOW: permit 47 host x.x.x.x host x.x.x.xActive SAs: ...
Hi,
I am connecting the router to a productive environment where we use higher port-channel numbers 100+. And it would be nice to match the port-channel numbers.
Where do you think I may ask this question?
Cheers
David