Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We are migrating from a Juniper SA4000 to an ASA for our SSL VPN connections. I am in the process of testing/configuring. When users connect through the SA4000, they are able to customize their user interface, which appears to be because the SA400...
Hi All,We went from CM 4.x to CM 6.1.2. We have several people that use IP Communicator. If they are on the LAN, works fine. If they are connected via a site-to-site VPN, works fine. If they connect through an SSL VPN and then Network Connect (it is ...
Here is what I have:rtrCore--rtrT1Core--T1rtr--SWIf I ping to the t1 interface on T1rtr, I get horrible response. It will reply, reply, request timed out...no real pattern, but over 50% of the packets are lost. If I ping to the Lan side of the t1rtr,...
We have a Cisco 1841 that currently connects to a 2821 via a radio link. They decided they wanted to use their old T1 line as a backup link. The T1 connection goes to a Cisco 7609. So I put the T1 card into the 1841 and connected it. I did not connec...
I have LMS 2.5. I have been trying to get the syslog portion set up. I get an error in the syslogcollector log that says unable to add monitor. I know next to nothing about syslog. I have tried to find info on the web, and it always talks about a Rem...
I am able to rdp. What I would like to do is to allow the user to customize the gui, since they have that ability now. As an example, under the heading "Terminal Services" there is a button that says "Add a terminal session" and under the Files headi...
I got it working. It was something on the firewall. Why it would work using CM 4 but not CM 6, I'm not sure. But there were SCCP Invalid Message/Invalid Length messages, so I looked on the firewall and found an application layer gateway setting that ...
No QoS. Really a very basic config. Not many people out at this site. I would say less than 10, so I can't imagine there being that much traffic. Plus, if there was a lot of traffic, wouldn't the ping response on the LAN side be horrible too? If I pi...
How do you reset the EIGRP session?fyi, the devices are connected like:1841(a)--wireless--2821--wireless--1841(b)--fiber--core.I did look at the two routers. I did a sh ip eigrp top active. The 2821 has a route in the ACTIVE state, the 1841(b) does n...
