Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am trying to find out if NBAR is supported on the 4507 switches with a Sup 6L-E module - I can't seem to find any info.Many thanks in advanceJason
Hi,Is it possible to create a NAT statement on an ASA that NATs a source address to an IP address that is not part of a subnet on the ASA?I want to NAT a source address from the inside interface to a public IP address. I will configure a static route...
Hi,We are currently utilising L2TP to tunnel PPPoE traffic and we are seeing some irregularities. How does Cisco IOS handle the following scenario: user logged on and authenticated via PPPoE and Radius. The user sends regular PPP echo messages. For s...
Hi,I am implementing an OOBM solution using a core 3845 router. The remote locations total 800 sites, so i need to know how many dialer interfaces a 3845 can support?I am expecting that there is a limitation and that multiple chassis will need to be ...
Thanks Amit,Do you know if there are any future plans to add NBAR to the switching roadmap?Also, what is proposed as best practice for classifying traffic at the access layer? Is it just using ACL at layer 4 or autoqos?Many thanksJason
hi John,I am thinking the following - the remote network already knows about the public IP address that I want to NAT to as it is already in use on the nokia fws - so all I am doing is moving the LAN connection of the Extranet router from one fw to a...
hi John,Ahhh - that is not good news.... the ASA takes the configuration, I tried it and it excepts it and shows the entry in the 'show nat' command!Thank you for your help.CheersJason
this is a part of a migration exercise where we have nokia fws in place and we want to migrate the extranet connections off those fws onto the ASAs. Problem is all the remote connxs hanging off the nokias are expecting a public IP address that the No...
Hi John,I can't ping the public IP address I want to NAT the source IP address to - I am hoping that the ASA will just translate the source RFC1918 address to a public address.The return traffic into the ASA will be achieved by configuring a static r...
