Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everybodyOur Nexus 5000 produce a lot of Log-Messages which we do not understand. Almost hourly (but not on a exact schedule), we get an entry: "%USER-2-SYSTEM_MSG: unknown enum 4 - xmlsa"System Reference, Google and a search on Support Community ...
Hi everyoneWe have a Problem with the default inactivity timeout values on our ACE A4. A Web-Service of ours takes up to 12 Minutes for creating its reports. But after 300 secs, the ACE kills the connection and sends a Reset to Server and Client, due...
Hi everbody Is there an official Cisco-Page with the always-up-to-date recommended NX-OS-Releases for the Nexus 5000, just as there is www.cisco.com/en/US/docs/switches/datacenter/sw/nx-os/recommended_releases/recommended_nx-os_releases.html for Nexu...
I have a strange issue with HSRP on my Nexus7000 resulting in a Active/Active-State.Does anyone see where the problem is founded or where I should look next?Thx in advance and Greetings from Berne,Stefan MuellerLayout2 Nexus 7000 with NX-OS 5.1(3) as...
Hi everbodyWe have to trace an issue where the DSCP-values of a voice-connection get lost somewhere - the packets are marked with DSCP 46 on the sending client, but are DSCP 0 on the receiving end. On IOS, there is the very handy command 'show mls qo...
Hi Shane5.1(3)N2(1) is a Nexus 5000-Release, the above Problem occured on a Nexus 7000, where 5.1(3) was another NX-OS-Generation.AFAIK, 5.1(3)N2(1) still is considered a good Release. The bug which stood behind my issue never was present on this rel...
Hi PeterThx for this one, most probably you are right as the problem occured when we tested DCNM and did not occur since. The Test-Installation of DCNM used the same user account as the LMS. Greetings from Berne, Stefan
Hi Ivan.There are no Users executing show commands at that time - but its possible that DCNM does so. I'll think about upgrading to 5.2(1)N1.Thanks for the quick Reply, Kind RegardsStefan
thanks a lot, this helped(although it isn't a global command: you have to config this for switch-mode and config advanced option for every VIP. A bit more of a hassle than we hoped for, but it works fine)
If DC2 is a backup-site for DC1, then you definitly need SVIs on DC2: If DC1 goes down, you won't have the DC1's HSRP-VIP anymore and all the servers in DC2 are standing still as well...
