Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
TopologyDetermine the ingress FEConfigure the TriggerInterpret the ResultsFurther Information This document provides the steps to perform an ELAM on the Nexus 7000 F2 modules, explains the most relevant outputs, and how to interpret their results. ...
TopologyDetermine the ingress FEConfigure the TriggerInterpret the ResultsFurther Information This document provides the steps to perform an ELAM on the Nexus 7000 F1-Module, explains the most relevant outputs, and how to interpret their results. P...
TopologyDetermine the ingress FEConfigure the TriggerInterpret the ResultsFurther Information This document provides the steps to perform an ELAM on the Nexus 7000 M-Series modules, explains the most relevant outputs, and how to interpret their resu...
TopologyDetermine the ingress FEConfigure the TriggerStart the CaptureInterpret the Results This document provides the steps to perform an ELAM on the Catalyst 6500 Supervisor 2T, explains the most relevant outputs, and how to interpret their result...
TopologyDetermine the ingress FEConfigure the TriggerStart the CaptureInterpret the Results This document provides the steps to perform an ELAM on the Catalyst 6500 Supervisor 720, explains the most relevant outputs, and how to interpret their resul...
Hey Stephan, The 'vpc bind-vrf' command allocates a special internal VLAN for routing traffic over the vPC peer-link to ensure L3 connections on the vPC peer or orphan ports successfully receive multicast traffic on N5k/N6k platforms. This workaroun...
Thanks dpita. I tried to install on a C220 M3. Everything appears to go well, and then when creating the partitions the install fails with the below traceback: Traceback (most recent call last): File "/usr/lib/insieme/anaconda.py", line 845, in <m...
Hey dpita,The release notes mention that the simulator is sold as an appliance. Also, it mentions that it runs on a Cisco UCS C220 M3:http://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/simulator/install/b_APIC_Simulator_Install...
Hi Finn,Yes, assuming that you're using the default 4q-8e queuing type on the F1, then all the same concepts discussed above are still applicable. -Andy
Hi Finn,You are absolutely correct on the dscp-to-cos mapping. I have updated the table in the previous post. In regards to your question, if you create an input policy that remarks DSCP value, then the CoS value will automatically be rewritten base...
