Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi!
We encounter a lot of this kind of syslog messages from our Flex 7510 controller. These can be identified to our Wi-Fi VoIP phones (Cisco 7925G). We have about 1500 phones connected to our controller. We are running software 8.0.152.0 on it.
Th...
Hi,I received new air-sap1602i-e-k9 access points and found out when configuring WDS that infrastructure authentication is using nowdays PEAP. Now our infarstructure authenticaton will fail for local certificate check from ACS 5.2. Does somebody know...
Hi,Our nat table does not time out all the udp rtp traffic from 792x wireless phones. Normal 7940/60 works fine and any other traffic. When the "left" time has counted to zero it goes to "timing-out" state and stays there unless we do manual "clear i...
We are using WDS and ACS 4.1 for 7921g and 7920 phones. It seems that 7920 is working great with LEAP but 7921g is always reauthenticating against the ACS RADIUS when roaming between APs. 7921g is having a few second gap for voice when romaming and a...
Hi,
Here is an output from console. First one is the latest that was dropped and two after that I randomly picket up from controller:
(Cisco Controller) >show client ccx rm 74:26:ac:65:f6:55 statusClient not in the unicast rm list(Cisco Controller)...
Hi, and thank you Jeffrey for the document.
Here is a short story how this went on my controller. It did not quite follow Jeffrey's instructions.
First I did not manage to access the controller with https. After the image failed to write to the flash...
I think that I have some kind of solution for this problem - in our case.I have been testing the solution for a day and it seems to be working.I enabled the CAC on a accesspoints but it did not help with the authentication problem. Then I noticed one...
I can see the passed radius authentications on the ACS side when 7921g is roaming. The CAC/TSPEC is a good idea to inspect. I have no expercience on CAC/TSPEC but I will test it and let you if it was the case. Do you have some good document to point ...
