Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey folks,I'm looking to set up an L3out with static routes for an Active/Standby Firewalls pair, as shown in the diagram below. However, I'm feeling a bit confused, especially when it comes to configuring the L3out with SVI. Any advice on how to pro...
Hi everyoneI have two question about cisco ACI leaf switches.1- is it possible convert uplinks to downlinks on Nexus 93240YC-FX2 in cisco ACI ? 2- all switches in leaf layer must be in same model? can i use multiple models in leaf layer?Many thanks
Hi everyoneI have some cisco Aironet 2800. i joined this access point to vWLC version 8.10.130. but after while they disconnected from wlc randomly. in first i check network connection between AP and WLC everything is ok, while access point disconnec...
Hi
I have a problem with integration NAM-2 service module and Prime Infra,
i add NAM-3 in Prime with HTTP and SNMP , but NAM-3 not show as Data Source, i also add Prime Infra in NAM-3 ,
anybody know cause of these problem?
Many Thanks
Hi @anpetit Thank you for your direct answer, based on your answer we can use QSFP-40/100G-SRBD on 8 uplink ports on switch N9K-93600CD-GX.Is there any documentation available that demonstrates the compatibility of using that transceiver on uplink po...
Hi @anpetit actually, I`v checked it, the problem is that switch support QSFP-DD on uplinks, but my spine switches don`t have 400G port (N9K-C9364C-GX), i want to know that is it possible use QSFP-40/100-SRBD on uplinks port or use down links as upli...
Hiif you have deployed it with Data-Store Domain, you can`t use the Desktop Client. the Desktop client will be available only in non-datastore domains.Thanks
HiNot a cause for concern. This is a simple process but i recommended to you use this procedure to upgrade WLC:1- before copy firmware file to WLC provide backup of your configuration2- after copy firmware file to the wlc, pre-download firmware to Ac...
Hi Guys Finally i can find problem, the core switch of my customer have problem with ARP table and lost ARP entries, This issue caused Keep-alive drop and capwap restarted. for temporary, I configure IP SLA on core switch to ping controller and acce...
