Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,Having issues enabling ssh on the Cisco 8300 router.I have configured hostname, domain name, authentication, rsa key, ip ssh version 2. but when i do sho ip ssh it saysSSH Disabled - version 2.0%Please create RSA keys to enable SSH (and of at...
Hi there,
Currently the accounts created using Lobby Admin account has a liftime of 30 days. Is there a way to increase the account lifetime ? Of is there a method to give to the reception an access to create guest accounts without giving full acces...
Hi Guys,
FYI last month I was activating licenses on Unity and ran in problems. When I was entering the PAK information the website was asking for Device UDI and Device serial number. I done a show license UDI and got the following information from ...
Hi Guys,
We have CUE running 7.0. Some of the phones have MWI on on their phones but there are no messages in their mailbox. I have checked via cli on CUE and can confirm there was no new messages for the phones which have MWI on.
I have dialed the...
Hi Guys,
I have a VPN setup as below. The VPN tunnel starts from the site router goes through the ASA and terminates at Palo Alto at Singapore.
Site Router NZ (VPN )---------------------------DC ASA----------------------------Internet ------------...
Hi David,Below is the config Cisco8300#show ip sshSSH Disabled - version 2.0%Please create RSA keys to enable SSH (and of atleast 2048 bits for SSH v2).Authentication methods:publickey,keyboard-interactive,passwordAuthentication Publickey Algorithms:...
Hi Terry,
Thanks for the reply. Yes it is not a new installation. We have around 120 phones and only 5 or 6 phones are having issues with MWI light being on.
Tried mwi refresh all on CUE but the issue still remians.
Any other suggestions which I c...
Hi Guys,
Below are the logs from the ASA. Thanks
Feb 17 21:28:21.582: ISAKMP:(0): retransmitting phase 1 MM_NO_STATE...*Feb 17 21:28:21.582: ISAKMP (0): incrementing error counter on sa, attempt 4 of 5: retransmit phase 1*Feb 17 21:28:21.582: ISAKM...
Thanks Rasika for the reply. I will try it tomorrow and will post the results. One question the dummy native vlan does it needs to be on all the links going between the switches and upto the WLC ? Also on the switch where AP is connected, do I need t...
